GPIO Status
The GPIO Configuration Status Bar Item provides properties to set DC Levels on J1 and J2 output connectors.
The J1 and J2 connectors on the front of the unit can be used to provide DC levels for custom uses. These values can range from -5.0 to +5.0 Volts. The default condition is 0.0 V. These settings are not saved and restored after power-cycle.
|
J1/2 Connector |
|
|
-5000 mV to +5000 mV |
J1/J2 are DC voltages supplied through a 50 ohm resistor suitable as controllable bias voltages for DUT testing. |
See Also